Wirlpool

Manual for the wirlpool

Read the manual before you enter the wirlpool. Your phone is not a fan of the bubbles :-)

Using shampoos or bubble baths is not permitted. The use of normal quantities of bath salts and bath oils causes no problems whatsoever.

Hydrosystem
When button 3 is pressed, the hydro system starts with 50% intensity (standard setting). The backlighting of the button is increased and, in addition, the backlighting of the buttons 2, 4 and 5 signals that these are also
enabled for selection.

The intensity can be increased or reduced by pressing the buttons 4 or 5.
The interval function can be activated with button 2. The intensity changes to the standard setting (50%) and cannot be changed. The interval frequency can be increased or reduced by pressing the buttons 4 or 5.

After approx. 30 sec., the backlighting of the buttons 2, 4 and 5 is switched off. They are no longer active. By pressing button 3 once, the buttons are
backlit again and setting corrections can be made. Pressing button 3 again switches off the function.

Hydro system + air system
The basic functions hydro system and air system can be activated in combination. The settings for intensity and for interval function can be done as shown at the basic functions. For setting, the corresponding basic
function must be always activated before.

Lighting
The halogen lamp is switched on and off by pressing button 7. The button backlighting is strong or weak. The halogen lamp can be switched on only
when the tub is sufficiently filled.

Cleaning function
When water is drained from the tub, the Hydro button (button 3) starts lighting until the tub is drained. After approx. 6 min the air system is automatically activated and flushes the remaining water from the pipework and the nozzles of the air system.